ALL CATEGORIES

SHOP BY INDUSTRY

DEALS

EXCLUSIVE BRANDS

NEW PRODUCTS

PUBLIC SECTOR

KNOWLEDGE CENTER

For removing bearings, gears, discs, etc. for tight or difficult-to-access spaces. <ul style="margin-top:0px; padding-top: 5px; padding-bottom: 5px;"> <LI> The thin pulling hooks are suitable for narrow, difficult-to-access locations.</LI> <LI> A manual adjustment knurl allows rapid loosening and adjusting of the extractor jaws on the cross-beam without using a wrench.</LI> <LI> Can be installed on various pulling hooks and variable reach thanks to jaw extensions.</LI> <LI> Turning the pulling hooks enables them to be used both internally and externally.</LI> <LI> Suitable for pulling asymmetric workpieces.</LI> <LI> Spindle head band prevents the wrench from slipping off.</LI> <LI> Cross-beam with hexagonal profile for good grip.</LI> <LI> Almost all components available as replacement parts, time-saving order process thanks to numbering system.</LI> <LI> Note: Pressure pads from series 600-17 are a good addition if the shaft is hollow and the spindle cannot be supported.</LI> <LI> Stability support from optional series 219 clamp.</LI></UL> Thin pulling hook with quick adjusting capability quick adjust. Parallel pulling hooks in every position, even with full load. Pulling hooks with infinitely variable adjustment on the cross-beam. Optimal adjustment of the spindle to the shaft with 2-sided spindle tip (ball and tip). Mechanical pressure screw. Milled thread treated with special coating. Two-arm design for space-saving operation. The pulling hooks sliding parts must always sit stably and fully on the cross-beam. If several parts have to be removed, always follow a step-by-step process. Do not remove several parts at the same time. The pulling hooks support surfaces must always be straight and sit fully beneath the part to be removed. Do not use any electrical or pneumatic servo screwdrivers or hammer drills. Protective blanket required. Protective goggles required. <ul style="margin-top:0px; padding-top: 5px; padding-bottom: 5px;"><li> Maximum Load (Metric) 2, 5t</li><li> Hexagon Drive (Male) (Metric) 17mm</li><li> Spread (Metric) 30 - 120mm</li><li> Spread Used Internal 2 3/4 - 7 1/8 "</li><li> Space Below 1/8 "</li><li> Maximum Torque (Metric) 35Nm</li><li> Space Next To It (Metric) 14mm</li><li> Space Next To It 5/8 "</li><li> Spread Used Internal (Metric) 70 - 180mm</li><li> Depth (Metric) 100mm</li><li> Space Below (Metric) 2, 6mm</li></ul>

Kukko Narrow 2-Arm, Revers Quick Adj 3.5-Ton Capacity, 4-3/4&quot;(120mm) Open, 3-7/8&quot;(100mm) Reach

narrow-2-arm-revers-quick-adj-35-ton-capacity-4-3-4-120-mm-open-3-7-8-100-mm-reach

Clearance Items

Customer Also Viewed

Save 15% Off

on all Auto-Reorders

with 5% off when you use your Global Industrial Credit Card.

% on your purchase when you use your Global Industrial Credit Card.

 suggested payments with 6 month special financing OR 

<a href="/contactUs">Customer Support</a>

<a href="/account/browse-history">Browse History</a>