JET® Cable Slide Wheel, JT9-HP35A-63

It is a genuine manufacturer-supplied part that is made for use with Jet and Wilton vertical bandsaws. The hinge-upper is a special component which helps to adjust the blade tracking. If the part is missing or is damaged, this will provide an identical replacement for the original part that was installed on a new unit. One durable metal hinge-upper is included. Check the owner's manual and the appropriate diagram for your model to ensure the proper repair procedure. A wrench set might be needed to remove the old component and secure the new one. For Use With: Jet 8201 (9078171) 14-Inch ...

This part is available as an individual replacement. The lower wheel attaches to the tire and is made of metal. A wrench may be necessary during the installation of this item. It may become broken and will need to be replaced. It is a genuine Jet part sourced directly from the manufacturer for use in band saws. For Use With: Jet JWBS-14CS (708115K) 14-inch Woodworking Band Saw JWBS-14CS (708115K) 14-inch Woodworking Band Saw

For Use With: Jet WB-25 (1790825) 25" Belt Sander 15HP 3PH 230/460V WB-37 (1790837) 37" Belt Sander 20HP 3PH 230/460V WB-43 (1790843) 43" Belt Sander 25HP 3PH 230/460V

Idler wheel for Wilton 4103 square wheel belt grinder (1998 and newer). Helps to apply tension to belt. Wrench required to replace. See model diagram for installation. Made In The USA.

This is a genuine replacement part sourced directly from the manufacturer. The wheel shaft is found in a square wheel belt grinder from Wilton. This part is made of metal, and is used to connect the contact wheel to the platen casting. You may require pliers when replacing this product. This item is sold as an individual replacement part. For Use With: Jet 4103 (5507796) Square Wheel Belt Grinder