JET® Motor Pulley 19Mm Jdp-20Mf, JT9-11037972

A genuine item which is supplied directly from the original equipment manufacturer for use with Shindaiwa handheld lawn and garden equipment. It is an identical replacement for a missing or worn -choke-label that was originally included with a new unit. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this item. Keep in mind this high-quality part is sold individually. For Use With: Jet JWBS-14CS (708115K) 14-inch Woodworking Band Saw JWBS-14CS (708115K) 14-inch Woodworking Band Saw JWTS-10JF (708301) Table Saw JWTS-10JF ...

This is a genuine part which is supplied directly by the original equipment manufacturer and is used with Jet arbor saws. The drive belt rests around the drive pulley. When engaged the belt spins the drive pulley which then transfers power to the motor. This part is made of rubber and is sold individually. For this repair you will need a screwdriver to remove the driver belt cover. To remove the old belt simply slide it off the drive pulley and place in the new one the same way. For Use With: Jet 72A 14" Tilting Arbor Saw

This item is sourced directly from the original equipment manufacturer. It is specially designed for use with Jet and Wilton sanders. The idler pulley helps to apply tension on the belt. Over time it may wear out or get damaged eventually requiring a replacement. It is made of high-quality material and is sold individually. Check the diagrams of your model for the exact location and the correct installation of this part. You will need a wrench set to remove and secure the hardware that holds the idler. For Use With: Jet 4002 (9078321) 8-Inch Disc Sander J-4002 (577003) Disc/Belt Sander

This is a genuine part that is supplied by the original manufacturer for use with Jet and Wilton drill presses. The drive belt connects the motor pulley to the spindle assembly to spin the chuck. This part is made of rubber and is sold individually. Be sure to disconnect the power before installing this part. The position of the belt will depend on witch speed you would like. Place the belt on one pulley and slowly stretch the belt while rotating the opposite pulley to fit into place. For Use With: Jet J-2221VS (354221) 20-in. Variable Speed Drill Press J-2221VS (354221) 20-in. Variable ...

This is a Genuine Manufacturer Sourced replacement part used on a Powermatic 66 10-Inch Table Saw. This part is made out of Rubber Material and it is Sold Individually. Clean the pulleys off before putting the new belt on to ensure top performance and longevity with your new belt. Inspect belts periodically and replace when worn to maintain peak performance. For Use With: Jet 66 10-Inch Table Saw 66 10-Inch Table Saw