Clesco, Pillow Block Ball Bearing, PBPS-BL-050, Self-Aligning, Pressed Steel Housing, 1/2" Bore

Features: Standard duty unit, set screw locking One-piece cast iron housing, solid base Wide inner ring bearing Dual heavy-duty slinger type contact seals Grease fitting for adding lubricant Anti-Rotation device Triple lip seals available on request

USDA & FDA approved, for wash-down applications in wet or harsh environments or where sanitary conditions are a factor. Self-lubricating bearings resist corrosion, high impact and abrasion. Two-piece stainless steel housing units. Tolerates -60° to 180° F. Flange Mount Bearings are available with housing units made from die-cast zinc, pressed steel and pressed stainless steel. Die-cast zinc housings are non-corrosive and lightweight with either a bronze bearing or ball bearing insert. Pressed steel housings come plated with a rust-proof finish and are available with bronze ...

Heavy gauge two-piece housing has rust proof plated finish. Housing is crimped together at bolt holes. Bearing insert with 2 set screws has longer inner race for added load support. Extra thick non-conductive rubber liner corrects misalignment up to 2 degrees while reducing noise & vibration.

Entire unit is UHMW-PE & USDA & FDA approved for up to -60 to 180 degrees. Ideal for wash down applications in wet or harsh environments or where sanitary conditions are a factor. Self-lubricating bearings resist corrosion, high impact & abrasion. Interchangeable with most metal units.

Ideal for applications requiring strong load support in limited mounting area. Solid Zinc die cast housing is non-corrosive and lightweight. Securely retains bearing by pressing the lip 360 degrees over the outer race. Includes 2 set screws.