JET® Main Screw Screw Jack, JT9-SJ15T-04

Contractor quality mechanical jack for all-purpose lifts and supports Holds heavy loads indefinitely - will not creep Heavy-duty bell shaped cast base Less effort required to lift capacity load with new design Corrugated steel swivel head turns easily under load Easy to carry and position with built-in handle Complies with OSHA, ANSI/AMSE B30.1 standards Turning bar not included

This is a genuine Dirt Devil upright vacuum belt. It fits vacuums that use a Style 4 or Style 5 belt. This is a flat belt which is used to transfer motion from the drive shaft to the brushroll. Th brushroll spins inside the suction nozzle in order to agitate the fibers of carpet or upholstery. This loosens dirt for a thorough clean. Note that the old belt may seem larger then the replacement belt because they get stretched out over time. One belt is included per package. For Use With: Jet JSM-403 1/2-inch Square Drive Impact Wrench

Contractor quality mechanical jack for all-purpose lifts and supports Holds heavy loads indefinitely - will not creep Heavy-duty bell shaped cast base Less effort required to lift capacity load with new design Corrugated steel swivel head turns easily under load Easy to carry and position with built-in handle Complies with OSHA, ANSI/AMSE B30.1 standards Turning bar not included

Contractor quality mechanical jack for all-purpose lifts and supports Holds heavy loads indefinitely - will not creep Heavy-duty bell shaped cast base Less effort required to lift capacity load with new design Corrugated steel swivel head turns easily under load Easy to carry and position with built-in handle Compliance: ANSI/AMSE B30.1 standards Turning bar not included

Contractor quality mechanical jack for all-purpose lifts and supports Holds heavy loads indefinitely - will not creep Heavy-duty bell shaped cast base Less effort required to lift capacity load with new design Corrugated steel swivel head turns easily under load Easy to carry and position with built-in handle Compliance: ANSI/AMSE B30.1 standards Turning bar not included