Oil Funnels

This high-density polyethylene jug is translucent for observing content level and includes a screw-top to seal container for safe transit. Screw-on funnel top with 12cm (4¾") diameter Perfect for safe handling and temporary storage of spent solvents or other liquid wastes Snap-on cap seals the funnel top to retain fumes Capacity: 20 liter (5gal); graduated in US gallons

This Lisle Oil Lift Drain 11102 is a specially shaped, translucent jug that holds 8 gallons. The reinforced base will not warp with hot oil. This item has a wide working range from 36 1/2" to 74". The lower center of gravity increases stability and four 2 1/2" ball bearing wheels swivel and roll easily. Also this lift drain has a heavy-duty adjustment clamp, a large handle, and a big pour spout with threaded cap. The large 15" funnel has a strainer built-in to catch drain plugs.

One piece HDPE plastic funnels with sealed-in, polyethylene filter plate of coarse porosity (90-130 microns) offer good retention and fast flow under vacuum. Can be used with or without filter paper For use below 52°C (125°F) Use with Vac-Ring Filter Seal (H38959-0000) for quick filter setup

Filter large volumes quickly with a polyethylene plastic Table-Top Buchner Funnel using your choice of Fritware®or Perforated filter plate. Removable hose barbed connector accepts 12.7mm (½") I.D. tube and threads into ¾" NPT bung on the funnel Fixed or removable Fritware®Porous Filter Plates supported by a multiple ring grid; HDPE, 6.4mm (¼") thick, with a non-porous ring at the periphery of the plate which seals filter paper when usedoFritware®Porous Filter Plates available in two porosities (medium and coarse); medium is 45-90 microns while the coarse is 90-130 microns; use temperature ...

Funnel King's® 4 Quart Drum Funnel with a lockable lid fits all 2" drum bung holes. Funnel, Flow Capacity 2 qt., Total Capacity 4 qt., Diameter 9-1/8", Polyethylene, Height 8.5", Length 9-1/8", Spout Outside Dia. 2", Red, Cover. Specifications: 10" approx top opening 1-1/2" approx bottom ID opening PPS threaded fitting that screws into a 2" drum bung hole