JET® Pulley Drive If, JT9-3610006

For Use With: Jet 8201 (9078171) 14-Inch Vertical Bandsaw 8201 (9078171) 14-Inch Vertical Bandsaw 8203 (9078171) 14-Inch Vertical Bandsaw 8203 (9078171) 14-Inch Vertical Bandsaw J-8201K (414500K) 14 Inch Vertical Band Saw J-8201K (414500K) 14 Inch Vertical Band Saw J-8203 (414504) 14 Inch Vertical Band Saw J-8203 (414504) 14 Inch Vertical Band Saw

For Use With: Jet 60B (1610077K) 8" 3HP 3PH 460V Magnetic Switch Jointer 60C (1610084K) 8" 2HP 1PH 230V Jointer 60C (1610085K) 8" 3HP 3PH 230/460V Jointer 60HH (1610086K) 8" 2HP 1PH 230V Jointer 60HH (1610087K) 8" 3HP 3PH 230V/460V Jointer

For Use With: Jet J-3410-2 (414455) 7x12 Cut-off Bandsaw J-3410-2 (414455) 7x12 Cut-off Bandsaw J-3410 (414454) 7x12 Cut-off Bandsaw J-3410 (414454) 7x12 Cut-off Bandsaw 3400 Bandsaw 3400 Bandsaw 3410 Bandsaw 3410 Bandsaw

Need more capacity from your Drill Press? Well take a look at the DP-2012F-HD-V3 Floor Drill Press to see if it will fit your needs. This mammoth has a 20" swing and a cast iron 16.5"x 18.5" oversized table and can handle just about anything that you can throw at it. The 3.6" diameter column and 24" x 16-1/2" cast iron base make for one rigid structure. Features: Drilling Capacity: 1-1/4" Runs on 220-volt single phase power Turns the MT4 spindle to 3200 RPMs The range of speeds is done using six pulleys that give the DP-2012F-HD-V3 12 spindle speeds It also includes a drill chuck that can ...

This is a genuine part which is supplied directly by the original equipment manufacturer and is used with Jet arbor saws. The drive belt rests around the drive pulley. When engaged the belt spins the drive pulley which then transfers power to the motor. This part is made of rubber and is sold individually. For this repair you will need a screwdriver to remove the driver belt cover. To remove the old belt simply slide it off the drive pulley and place in the new one the same way. For Use With: Jet 72A 14" Tilting Arbor Saw