Supco Freeze Protection Control

Zurn 112-950XLT2 1-1/2 In. FNPT x FNPT Double Check Valve Assembly - 175 PSI - Lead-Free Cast Bronze Designed for installation on potable water lines to protect against both backsiphonage and backpressure of polluted water into the potable water supply. A test cock plug is provided to protectagainst fouling caused by insects, dirt and debris. Assembly shall provide protection where a potential non-health hazard exists. Standards Compliance Unless otherwise noted, applies to 3/4" thru 2" Horizontal ASSE® Listed 1015 (Vertical flow-up:1 1/4" thru 2") IAPMO® Listed CSA® Certified (Vertical ...

Zurn 34-SXL 3/4 In. FNPT x FNPT Strainer - 20 Mesh Screen - 300 WOG Lead Free Cast Bronze Recommended for a variety of water service lines including residential and commercial irrigation, swimming pools and cooling tower water. They are also designedto protect delicate equipment such as regulators and backflow preventers by filtering sediment which could cause premature failure. Standards Compliance NSF® Listed - Standard 61, Annex G Certified to NSF/ANSI 372 by IAPMO R&T

Field Controls 8 Power Venter 740,000 BTU SWG-8 Patented SWG Venter is ETL and cETL listed for all LP gas, natural gas, or oil-fired heating equipment. Combines the motor, blower, and vent hood in one complete, easy to install unit. The SWG mounts on the outside of the building and pulls the combustion gases from the appliance through the outside wall utilizing 100% negative pressure. Made in the USA. Benefits: 100% negative pressure in the vent pipe for maximum safety. Standard galvanized pipe can be used instead of expensive stainless steel. No need to seal vent pipe joints, saving time ...

Zurn 2-SXL 2 In. Strainer - FNPT x FNPT - Lead Free Cast Bronze - 20 Mesh Stainless Steel Screen Recommended for a variety of water service lines including residential and commercial irrigation, swimming pools and cooling tower water. They are also designedto protect delicate equipment such as regulators and backflow preventers by filtering sediment which could cause premature failure. Standards Compliance NSF® Listed - Standard 61, Annex G Certified to NSF/ANSI 372 by IAPMO R&T

Features: Simple direct coupling reduces installation and commissioning time while improving reliability by eliminating damper linkages Robust 140 lb-in (16 Nm) torque rating Rotation range 0 to 90° in 5° increments, mechanically limited to 93° Fits 3/8 to 3/4 (10 to 20 mm) round shaft, 3/8 to 5/8 (10 to 16 mm) square shaft; 1 (25.4 mm) diameter jackshaft with M9000-154 adapter On-off, floating and proportional control inputs meet the needs of most applications Output position feedback provides simple closed-loop control with accurate position sensing Master/slave operation ...