JET® Vise Base - Vsf-14, JT9-5519813

For Use With: Jet J-7015 (414450) 8-in x 13-in Horizontal Cut-Off Bandsaw J-7015 (414450) 8-in x 13-in Horizontal Cut-Off Bandsaw

For Use With: Jet WB-43 (1790843) 43" Belt Sander 25HP 3PH 230/460V

This replacement ultra smart belt is specially produced for Eureka upright vacuums. It is a high quality OEM sourced item that drives the brushroll assembly. Over time belts tend to wear out and stretch eventually requiring replacement. It is advised to replace this belt every 6-12 months to ensure optimum performance. Please note, these are sold in a pack of two. For Use With: Jet GHD-20 (354020) Gear Head Drill / Tap GHD-20T (354024) Gear Head Drill / Tap GHD-20 (354020) Gear Head Drill / Tap GHD-20T (354024) Gear Head Drill / Tap

Hydraulic cylinder assembly for JET band saws 7020/7040. 3 in. Fits into bottom support and is secured between saw arm and base. Controls level of force in the saw motion. See model diagram for installation.

For Use With: Jet C-1 (Before 1998 Old) Combination Pipe and Bench Vise C-1 (Before 1998 New) Combination Pipe and Bench Vise C-1 (After 1998) Combination Pipe and Bench Vise 400 (After 1998) Machinist Vise 450 (After 1998) Machinist Vise 500 (After 1998) Machinist Vise 400 (Before 1998 Old) Machinist Vise 400 (Before 1998 New) Machinist Vise 450 (Before 1998 Old) Machinist Vise 450 (1971) Machinist Vise 500 (Before 1998 Old) Machinist Vise 500 (Before 1998 New) Machinist Vise