Pullers & Separators

Made in Germany, Adjusted reach to provide larger depth range, Three jaw design ensures the load is distributed evenly. The 3-armed lug puller "Economy" with oscillating and height-adjustable puller legs is used for pulling off bearings, gears and washers in all common sizes for crafts, workshops and industry. The oscillating and curved puller legs adapt to any installation situation and can be used universally due to the adjustable clamping depth. The 3-arm design guarantees an even load distribution and thus a particularly secure hold on the part to be extracted. Range of Application: ...

For extracting inner bearings, bearing outer rings and bushings. KUKKO internal extractors can be combined with counter supports and slide hammers. When combined with the internal extractors, extensions from series 21-V enable deeper bearings to be extracted. Spare parts are available for internal extractor sizes 21-89 and 21-90. The 2-shell design with extra large grasp edges ensures safe extraction. The internal extractors are equipped with an internal safety stop to protect against excess spreading and overloading. Mechanical pressure screw. Do not use any electrical or pneumatic servo ...

Universal set for turning off out worn bolts, etc. Practical package for universal use. Complete easy-to-manage package. Almost all components available as replacement parts, time-saving order process thanks to numbering system. Instructions and conversion table in the cover. Secure storage in special foam. Personal KUKKO-Chip-Code. Do not use any electrical or pneumatic servo screwdrivers or hammer drills. Protective blanket required. Protective goggles required. Screw Thread (Metric) M5 - M16 Drill Diameter (Metric) 3, 2 - 8, 7mm

For extracting ball pins when dismantling ball joints, track-rod ends on track rods. Almost all components available as replacement parts, time-saving order process thanks to numbering system. Bell-shaped design, Direct pressure on the ball pin, Ideal if enough space is available, Working without damage, Made from sturdy, alloyed, hardened and tampered steel, galvanized. Milled thread treated with special coating. A torque wrench is recommended for the drive Never use an electric- or pneumatic-powered impact/hammer drill for driving a pulling tool. Protective blanket required. Protective ...

For removing small bearings, gears or discs, etc. for tight or difficult-to-access spaces. This handy, space-saving model is particularly suited for vehicle electrical equipment, electrical workshops, compressed air repair processes and other similar applications. The thin pulling hooks are suitable for narrow, difficult-to-access locations. Almost all components available as replacement parts, time-saving order process thanks to numbering system. Thin pulling hooks. Automatic self-centering pulling hooks. The three-arm design ensures that the load is distributed evenly and that the part ...