JET® Blade Guide Support Lower, JT9-8020FW-182

It is a genuine manufacturer-supplied part that is made for use with Jet and Wilton vertical bandsaws. The hinge-upper is a special component which helps to adjust the blade tracking. If the part is missing or is damaged, this will provide an identical replacement for the original part that was installed on a new unit. One durable metal hinge-upper is included. Check the owner's manual and the appropriate diagram for your model to ensure the proper repair procedure. A wrench set might be needed to remove the old component and secure the new one. For Use With: Jet 8201 (9078171) 14-Inch ...

This is an authentic replacement part manufactured for use with verticle band saws. The special set screw is commonly used to secure the carbide blade guide to the support bracket. This set screw is available as an individual replacement part, please note two set screws may be required. For Use With: Jet 8201 (9078171) 14-Inch Vertical Bandsaw 8201 (9078171) 14-Inch Vertical Bandsaw 8203 (9078171) 14-Inch Vertical Bandsaw 8203 (9078171) 14-Inch Vertical Bandsaw 8201VS (9078171) 14-Inch Vertical Bandsaw 8201VS (9078171) 14-Inch Vertical Bandsaw J-8201K (414500K) 14 Inch Vertical Band Saw ...

This is an original Jet-Wilton replacement part. The metal blade wheel is used in bandsaws to hold and turn the circular saw blade. You may want to replace both the front and rear blade wheels at the same time for even wear. If the blade wheels on your band saw have a tire, please be aware that the blade wheel does not come with the tire installed, so you may also want to purchase a new tire. You will need a hex or Allen wrench to replace this item. For Use With: Jet J-3410-2 (414455) 7x12 Cut-off Bandsaw J-3410-2 (414455) 7x12 Cut-off Bandsaw J-3410 (414454) 7x12 Cut-off Bandsaw J-3410 ...

It is a genuine item that is supplied by the original manufacturer for use with Jet and Wilton bandsaws. This is the special center shaft that helps to secure the blade. It provides an identical replacement for a damaged or a missing component that was installed on a new unit. Ensure the correct installation of the new part by referring to the owners manual and the appropriate diagrams of your specific model. Note, this high-quality shaft is made of durable metal and is sold individually. For Use With: Jet J-7020M (414474) 10"x16" Miter Cut-Off Bandsaw J-7020M (414474) 10"x16" Miter ...

This item is a genuine part that has been sourced from the original manufacturer to be used with verticle bandsaws from Wilton and Jet. The durable plastic insert fits into the cap in the table where the blade passes through the table. The insert is used to reduce the gap around the blade in order to better support the material as it is being cut. Inserts wear down from normal use, and will eventually need to be replaced to maintain clean accurate cuts. This part is priced as a single item, please note tools may not be necessary to install the insert. For Use With: Jet 8201 (9078171) ...