Parts & Accessories

K-type pipe clamp temperature probe for hands-free superheat/sub-cooling temperature measurement without the use of tape or VELCRO®Brand. Spring-loaded jaw for secure grip on pipes from 0.25 In. (6.35 mm) up to 1.5 In. (38 mm) diameter. For use with any thermometer or MultiMeter with a type K thermocouple input. Measurement range: -4 to 200°F (-20 to 93°C). Complete with: 36 In. Cable Type K connector VELCRO® is a registered trademark of Velcro BVBA, used with permission.

Extech 445815 Hygro-Thermometer with Dew Point In summertime, identifies and warns when conditions for mold growth exist. In wintertime, identifies and warns when low humidity conditions for static electricity exist. Remote probe allows for measurements behind walls or in difficult to access locations. Air temperature and dew point temperature indicate where condensation may occur. Monitor conditions in laboratories, storage areas and other controlled environment settings. Ideal solution when traceable ISO calibrations are required by operating standards.

Extech 461995 Combination Tachometer with Laser Tachometer memory stores last, max and min readings. Provides wide RPM (photo and contact) and Linear Surface Speed (contact) measurements. Accurate to 0.05% with max resolution of 0.1 rpm in either photo or contact mode.

Extech HD350 Pitot tube and anemometer diff manometer Large LCD display with backlighting. Zero function for offset correction or measurement. Store/Recall up to 99 readings in each mode. USB port includes software.

Tektronix CT2 High-frequency Current Probe, 200 MHz 36A, Includes: Manual, P6041 Interconnect Cable The Tektronix CT2 High Frequency Current Probe is designed for permanent or semi-permanent in-circuit installation. The Tektronix CT2 probe consists of a current transformer and an interconnecting cable. The current transformers have a small hole through which a current carrying conductor is passed during circuit assembly. The P6041 Probe Cable provides the connection between the Tektronix CT2 Current Transformers and a BNC oscilloscope input. A 50 Ω termination is required to terminate ...