JET® 2 Table Insert Jbos-5, JT9-6286980

This is a genuine OEM replacement table Insert used on Jet band saws. Table Saw Inserts reduce splintering and chip-out on the cuts. It also prevents thin slices of wood from jamming in between the blade and the plate during a cut. If an insert is missing or damaged it needs to be replaced. This part is made out of metal and it is sold individually. For Use With: Jet JWBS-14DXPRO Delux Pro Band Saw JWBS-14DXPRO Delux Pro Band Saw JWBS-14CS (708115K) 14-inch Woodworking Band Saw JWBS-14CS (708115K) 14-inch Woodworking Band Saw JWBS-14OS (708113A) 14-inch Woodworking Band Saw JWBS-14OS ...

This is a genuine Wilton replacement part for use with vises. The Serrated jaw inserts with used as a replacement jaw that fits on the sliding and stationary jaws. When the jaw is tightened down it will securely hold the workpiece. To install you will need an allen wrench. The components are made of high-quality metal. The item is sold individually. For Use With: Jet C-0 (Before 1998 New) Combination Pipe and Bench Vise C-0 (After 1998) Combination Pipe and Bench Vise 350 (After 1998) Machinist Vise 350 (Before 1998 New) Machinist Vise

This is a genuine replacement part which is sourced directly from the original manufacturer for use with Jet and Wilton vises. The jaw is an important component which helps to provide a tight grip. It provides an identical replacement for a missing or a damaged part that was installed on a new unit. You may require a screwdriver or wrench when replacing this item. Two durable metal vise jaws and the hardware to secure them are included. Refer to the owner's manual of your model for the correct application. A screwdriver will be needed to perform the repair. For Use With: Jet 745 ...

For Use With: Jet CBV-100 Clamp-On Vise SBV-100 Bench Mounted Vise

This item is a genuine part that has been sourced from the original manufacturer to be used with verticle bandsaws from Wilton and Jet. The durable plastic insert fits into the cap in the table where the blade passes through the table. The insert is used to reduce the gap around the blade in order to better support the material as it is being cut. Inserts wear down from normal use, and will eventually need to be replaced to maintain clean accurate cuts. This part is priced as a single item, please note tools may not be necessary to install the insert. For Use With: Jet 8201 (9078171) ...