Honeywell Pressuretrol® Limit Controller L4079B1033, Manual Reset, 2-15 PSI, 14-1 KG/CM²

Honeywell L4064B2228 - Fan and Limit Controller The Honeywell L4064B2228 fan and limit controller includes 125F fan on and 100F fan off stops, 200F high limit stop and 5 in. insertion. For control of high limit and fan motor in all types of forced air heating systems. Features: The Honeywell L4064B2228 includes three available wiring terminal options for easy installation; push-in receptacles for stripped wire, female receptacles for 1/4 in. male flag connectors, and field add-on screw terminals. The Honeywell L4064B2228 controller's controls adapt to many competitive mounting holes in ...

Honeywell L408J1009 Honeywell L408J1009 Vaporstat Controllers provide operating control & automatic high limit protection for vapor heating systems with pressures up to 4 psi (8 kPa). All models have Microswitch snap switches to open or close a circuit on a pressure rise. Stainless steel diaphragm made for use with liquids, air, noncombustible gases, ammonia, oxygen, distilled water and similar media. Provide SPDT switching. Clear plastic cover allows observation of the pressure settings. Mount using hexagonal fitting with 1/4 in. NPT internal threads for direct mounting to the 14026 ...

The Honeywell L4064B2210 is a Fan and Limit Controller with 125 F fan on and 100 F fan off stops, 200 F high limit stop and 11 1/2 in. insertion. For control of high limit and fan motor in all types of forced air heating systems. Features: The L4064B2210 includes three wiring terminal options available for easy installation--push-in receptacles for stripped wire, female receptacles for 1/4 in. male flag connectors, and field add-on screw terminals. Adapts to many competitive mounting holes in replacement applications and available in a variety of fan and high limit setting ranges. Has ...

The MAXsa® 10 controller offers a single monitoring and control point for the entire hard automation welding system. Operators have full control over AC and DC welding parameters and easy PLC interfacing to control fixture travel, timers and other system commands. Features: Severe Duty Ready - The controller is IP23 rated and ready for operation in harsh environments Pendant Box - Mount the controller in the standard protective box or remove the pendant for hand-held operation Eight Procedure Memories - Pre-set and save your optimal welding parameters for repeating applications and recall ...

Features Provide operating control with automatic limit protection for pressure systems up to 300 PSI (2068 KPA) Use with steam, air, noncombustible gases, or fluids non-corrosive to pressure sensing element Models have snap-acting switching to open or close a circuit on pressure rise Have adjustable differentials Adjustments are made by screws on top of case Mount using 1/4 inch -18 NPT internal pipe threads or surface mount through base of case Ground screw terminal