Baileigh Industrial Manual Slip Roll, 24" Width, 20 Gauge Mild Steel Capacity

This manual metal shear makes it easy to cut thin steel plate. The compact 8G is perfect for shops that do small runs and don't have room for large, permanently mounted machines. 3/16" mild steel sheet metal capacity. .236" round mild steel capacity. 8" blade can cut a 7"-wide piece of sheet metal. Blades are polished for longevity. Fully adjustable blade gap helps prevent burr and blade damage. Includes a handy material hold-down. Gear system is connected to the pull-down handle for efficiency. Covered by a 1-year parts warranty and lifetime technical support by phone. Recommended for : ...

Built of fully integrated and welded all-steel plate, this pneumatic shear will last for many years. The air powered sheet metal shear is perfect for schools and shops cutting 16 gauge mild steel or lighter. Order this air sheet metal shear from Baileigh Industrial today. Cuts up to 52"-wide sheet metal. Requires only compressed air between 90 and 115 psi.* No electrical power needed. Regulator lets you control the airflow. Can cut at 20 strokes per minute for high production. High-chromium carbon blades have multiple cutting surfaces for extended life between re-sharpening. Oilers make ...

Built with oilers and a rigid steel frame, this heavy-duty manual shear will last for many years and give you accurate cuts. The fit and finish of this stomp shear are unrivaled in the industry. Can cut 16 gauge mild steel over its entire 52" length. Easy to operate: just put material between the blade and the table, then stomp on the pedal. 4-sided high chromium blades can be turned and also resharpened to extend use. Front gauge and backgauge, each with 24" long, help you make repeatable cuts every time. Oilers make maintenance easy and allow you to keep the machine running smoothly ...

Built with a welded tube frame, this compact entry-level English wheel can smooth compound curves into 18 gauge mild steel. The EW-28 includes all the tooling you'll need: 6 lower rolls. Ample 28" throat depth. Comes standard with an 8" x 2" upper roll. Includes lower anvil rolls with 6 different radii: 2", 3", 4", 6", 8", and 12". Arrives intact with only minor assembly required (no welding needed). Fully welded, heavy-walled square tubing frame helps eliminate flex when forming at maximum capacity. Rigid steel stand is built to withstand years of hard use while shaping mild steel and ...

The SN-F16-HN manual corner notcher is a high quality cast ironsheet metal notcherperfect for any garage or sheet metal shop. The cutting angle is fixed at 90 degrees and can notch up to 6" x 6" in one manual stroke. For your safety we have included a blade guard to save your fingers. Because of the high quality components used to make the SN-F16-HN, the finished notches are extremely clean and have burr free edges. The SN-F16-HN sheet metal notcher includes a sturdy floor stand, freeing up valuable worktop space. Take it off the stand and you have a machine that is very compact and can ...