Keysco Suction Disc, Steel/Rubber, 8"W x 4"D x 8"H

cFrom light to heavy pulls The Maxi has the power and the accesories to do it all. Pull by hand with pull rod or attach the slide hammer rod for heavier action. Pull creases evenly with the "Wiggle Wire" and Bear Claw" system. The leverage bar assists in power pulling, but also allows delicate pulls along moulding lines. Weld stud pins to create a strong pulling tab or use the shrinking tip to correct over-stretched metal. 21 feet of power and 9 feet of weld cable make sure the technician can reach anywhere on the vehicle. Made in the USA with a five year warranty.

Provides excellent balance with 5lb. slide weight on plated, solid, 5/8" shaft. Exclusive soft cushion vinyl grip with "Hang-It" hole absorbs shock. Broached nose cone locks puller screw firmly in place. Supplied with body hook of heavy duty aircraft steel for pulling out curled and creased edges and panels. Helps in aligning hood and trunk hinges. Heavy duty puller screw is extra long. Designed for that in-between job where the 10 lb. Slugger slide weight is too heavy and the pullers with 3 lb. weights are too light. Nose cone and shaft threads are 5/8"-18.

Setting the perfect gap width when aligning body panels and hoods just got a lot easier thanks to the DF-PG213 Perfect Gap Gauge from Dent Fix Equipment. No longer does the technician need to eye the appropriate width. Now with the DF-PG213, all the guess work is removed from the process allowing the technician to set the width to the factory specifications. The felt covered magnets provide a solid mounting point on steel panels and the reverse side has a suction cup for aluminum and plastic panels. After adjusting the horizontal bar, the appropriate number of gauge tabs can be positioned ...

The Parking Sensor and Lens Hole Maker (Part No. DF-EZ10) from Dent Fix Equipment is the precise and clean way to create holes in order to install driver assist sensors on replacement bumpers. Easy to use with a wide variety of sizes make this tool a must have for any shop.

The Keysco Sheet Metal Hooks are specially designed for newer car bodies with hard to reach hook-up positions. The hooks are made of high strength 3/4 inch diameter steel and are heat treated and plated gold. Hook assortment comes with both round and chisel pointed tips and has a maximum pull strength of 2500 lbs.